Material details

Aluminum is a very bright silver-colored metal. It is ductile, soft and very light. It is very resistant to oxidation.

Description

The process of laser cutting on metals it is different from the other materials in the catalog. Before proceeding to laser cutting on metal, be sure to read these important information:

  • it is not possible to share cutting lines
  • you will only receive the cut pieces, not the rest of the plate. It is not possible to receive both positive and negative. If you intend to make one stencil you have to draw the border around your drawing and you will only receive the mask.
  • the objects must have an area of at least 10x10mm (the grid on which the slab rests is very large, the smaller pieces of this size will fall and it will not be possible to recover them)
  • the elements on the template must be 6mm apart from each other
  • it's better avoid details with a width of less than 1mmbecause they could be burned away and not be on the final object
  • it is also necessary to create "carrier" details of width equal to or greater than the thickness of the material. In any case never less than 1mm. For example, if I choose to use a 3mm plate, the minimum thickness within my design should be 3mm. If I choose to use a plate with a thickness of 0.5mm, the minimum thickness within the design must be 1mm.
  • draw using only closed paths
  • before cutting an object, the laser can drill on the outside of the cutting line
  • in the smaller elements, the corners may be rounded
  • the back of the material will be slightly satin for the process of cleaning and removing the burns after cutting
  • can make incisions using the average vector engraving (green colour). It is not possible to make incisions of different intensities or raster engravings.
  • If in doubt, write a note before adding your drawing to the cart!

Technical details

Aluminum is a very shiny silver-colored metal. It is ductile, soft and very light. It is very resistant to oxidation.

After cutting, the objects are cleaned mechanically to remove stains and smudges due to the laser cutting. Nevertheless, there may be some "burrs" in areas that are difficult to reach, with dimensions no greater than 1mm, due to a slight melting of the material. Parts near the cut can change color. Everything can be removed and cleaned with specific abrasive paste for steel (even detergents commonly used in the home), solvents or sandpaper.

Aluminum is recyclable.

It can be worked with mechanical tools and fixed or joined with small metal parts. It can be welded. For gluing onto other materials, specific glues can be used.